Ran this under a 64mm on my VP truck for less than 400 miles. Too much turbo for my setup. $1700 shipped. They are $2200 from stainless diesel plus shipping.
http://www.stainlessdiesel.com/index.php?route=product/product&keyword=5%20Blade%20Mafia%20S480&product_id=329
Billet polished race cover S466. Exhaust is the 80-87 and it has a BEP stainless polished 1.0 T4 v band. Ran it on my vp44 truck. Would see 60psi boost and 55psi back pressure. Had the turbo rebuilt around 5,000 miles ago. I'll post pics tomorrow. Five 71-220-7160
I just bought a twins kit minus the bottom turbo. The top for the kit is a 62/65/12 t3 of course. I decided I'm putting the Billet S475 I bought last year under it. While I was looking for the 475 I found a turbo I bought a couple years ago that I think might work good for the twin setup. Turbo...
The catch is I want to keep it a VP truck and I need to be able to tow with it. I've been towing with the huge single I have but I'm towing a lot more often 8-12,000lbs. I'm past the drag racing stage finally but still want the truck to get up and go. The top turbo will be a 62/65/12 but I don't...
Just swapped over to a Detroit locker and 4.10's. limite slip was rebuilt 14,427 miles ago exactly. Gears have 133k on them.
Dana 70 limited slip- $225 shipped
Dana 70 3.54- $75 shipped
Dana 60 3.54 front- $75 shipped
CPP 7x.010 w/lift injectors. They have 13,000 miles and I was told they were around 175-200hp injector. No cores needed $570 shipped
Stock 24v manifold no cracks. $125
ATS T3 manifold. Had the manifold heat coated with Cerokote (flat black) $350
BD super b turbo. 40,000 miles Looking to...
I'm putting a 66mm on this week and plan on spraying it. I'm going to the the T4 gate plate to run the wastegate off. What size and type of wastegate should i get and where should i start at for getting the wastegate to open up before it builds too much boost? I'd like to limit the boost to 55lbs.
I have a new autometer C2 60psi boost gauge in the box and a new trans temp gauge for sale. $110 shipped for both. They come with everything for install
whats the best spray angle for a 24v? I'm going to be putting a gt3782(possibly 3788) over a GTX4294R and will need to change injectors. I'm looking for the best possible setup for injectors and have seen some people talking about different spray angle's.
Well i had an injector hang open and melted #6 piston. I want to put a .020 over long block in it but was trying to find a good reputable place. I'm also going to put some Warren 155cc's while im at it and hopefully not have to worry about injectors for awhile too. Any help would be appreciated...