Search results

  1. A

    sanden SD7H15 AC compressor

    Hi everyone, I'm hoping winter is soon done. Which means AC needs to be repaired . I have the Sanden SD7H15 compressor, which I suspect, is leaking. I have done reading that Sanden has an enhanced SD7, which is advertised as a much more efficient compressor. Any one ever do this, or heard of...
  2. A

    48RE problems need a home run shop

    Hi, I have my buddy's 06 CTD and its been in the transmission shop 4 time in the last 6 months with burned clutches. The shop towed it to his house and totally gave up. The shop told him that 50# of pressure was all he could get at an idle, he said its suppose to be 75#. We are looking for a...
  3. A

    2001 Fummis AC

    OK, I'm down to the AC on my conversion. I'm using the Sanden SD7H15 with a new condensor, and dryer. What has worked in the past or what not to do? I plan on PAG 46 the compressor some, and the rest in the dryer? The Ford's calls for just under 3# of r134a and plan on using the Sanden's oil...
  4. A

    Sanden vs Visteon

    Hi, I have a Sanden SD7H15 on my Cummins and would be interested if my old AC compressor from the 2001 F350 7.3L would bolt in the Cummins place, just the mounting not anything else? And is one a better compressor than the other?Thanks, Artie
  5. A

    Another Fummins Build Thread

    Some more pics, I hope
  6. A

    Another Fummins Build Thread

    Here's what I did for the hot side of my innercooler. Very tight, but works, Artie
  7. A

    turbo outlet temps?

    Hi, I need to know what the most exterme temp that an compressors side going TO my innercooler's heat would be? I would like to use some alum solder / brazing on the inside of my outlet, the melting point of my alum filler is 730* I don't want my filler to melt into my intake. Just want to be...
  8. A

    Fummins cabin noise

    Hi, I cannot believe that the Cummins in my 01 F350 is so noisy. I replaced the cowl boot seal, installed sound deadner on the trans hump. I had a chirp when I deacceled and tightened up my mtr mounts. The mounts are from Diesel specialists and the engine got louder after I tightened them down...
  9. A

    innercooler ends?

    Hi, I was wondering if someone has a cool way to put the crimp on the end of these pipes so pressure won't blow them off?
  10. A

    Fummins lower hose deal

    Has anyone besides Meyers Farms conversion got a better deal on lower hose? Getting around the AC pump is a challenge. I don't want to route my hose(s) in the path of the engine fan.... (if needed). I have thought of removing the AC bracket/outlet and welding a tight 90* to clear the AC pump and...
  11. A

    turbo oil drain

    Hi I have a industrial manifold on my Fummins project and I would like to know if I can remove the drain in the block and clock it? Or where is there a flexible drain hose kit? Thanks, Artie
Top