gainer16
New member
- Joined
- May 25, 2008
- Messages
- 364
02 GMC puller rolling chassis
--------------------------------------------------------------------------------
complete rolling chassis set up for 2.6/2.8 and even 3.0 classes. it is a crew cab shortbed 2002 red gmc.
here is a list of the set up:
eaton e locker front
upgraded grizzly rear welded
scs axles
6 in billet aluminum driveshaft
also 4 inch steel driveshaft
drivesaft loops and u-joint shields
sled stops
kill switch
both tcm and ecm come with
suspension stops
weight bracket
3 link traction bar set up
yukon 4.56 gears front and rear
roll pan
tie rod sleeves
centerlink
18x10 diamo rims with 35x12.50 truxs up front
315 bfg duals on rear
reese tow beast class v receiver
custom pulling hitch
labonte water injection system
hood stack or bed stack and i have original factory hood as well
new wheel bearings
new napa brand heavy duty cv shafts
leather interior still complete
only 90k miles
set up for an automatic
body is in near perfect condition
also have propane injection system and nitrous kit i will throw in for a little extra cost if interested
*does not come with motor, trans, or intercooler. rolling chassis only*
good very clean setup, does not bounce in any sort of way. goes straight down the track! ready for your motor and trans and go pulling or could be placed back on the street!
$20,000 with pulling rims and tires
$17,500 with stock pyo rims and tires
willing to take offers as well
--------------------------------------------------------------------------------
complete rolling chassis set up for 2.6/2.8 and even 3.0 classes. it is a crew cab shortbed 2002 red gmc.
here is a list of the set up:
eaton e locker front
upgraded grizzly rear welded
scs axles
6 in billet aluminum driveshaft
also 4 inch steel driveshaft
drivesaft loops and u-joint shields
sled stops
kill switch
both tcm and ecm come with
suspension stops
weight bracket
3 link traction bar set up
yukon 4.56 gears front and rear
roll pan
tie rod sleeves
centerlink
18x10 diamo rims with 35x12.50 truxs up front
315 bfg duals on rear
reese tow beast class v receiver
custom pulling hitch
labonte water injection system
hood stack or bed stack and i have original factory hood as well
new wheel bearings
new napa brand heavy duty cv shafts
leather interior still complete
only 90k miles
set up for an automatic
body is in near perfect condition
also have propane injection system and nitrous kit i will throw in for a little extra cost if interested
*does not come with motor, trans, or intercooler. rolling chassis only*
good very clean setup, does not bounce in any sort of way. goes straight down the track! ready for your motor and trans and go pulling or could be placed back on the street!
$20,000 with pulling rims and tires
$17,500 with stock pyo rims and tires
willing to take offers as well