'06 Built Cummins CR engine part out

Do you know the o-ring groove specs or if it will work on 6.7 bore/block?
 
The Rings are 4.550 x .105. I cut grooves in the head and block so the grooves would need to be cut deeper if just cutting head. I'm not 100% sure if it will fit a 6.7 block.
 
Flex plate is sold.

The head is at the machine shop getting checked over and cleaned for the future new owner. Make an offer.
 
Head is back from the machine shop from being gone through and cleaned. Ready to deal on it. $2,000 or $2,500 with ZZ fab side draft.
 
Carrillo Rods: $2,000 shipped
Monotherm pistons(.020) - $2,000 shipped
Haisley cast cam - $400 shipped
Port and polished head(shelf milled off/103# valve springs/titanium keepers head is o-ringed ZZfab side draft - $2,500
Crank -$500 plus shipping
Block and Kennys 5/8 Girdle - $900 plus shipping
Fuel rail and all lines - $100 plus shipping
Alternator $100
Front housing and cover $100 plus shipping
Trans adapter - $100 plus shipping
 
Carrillo Rods: $2,000 shipped
Monotherm pistons(.020) - $2,000 shipped
Haisley cast cam - $400 shipped
Port and polished head(shelf milled off/103# valve springs/titanium keepers head is o-ringed ZZfab side draft - SOLD
Crank -SOLD
Block and Kennys 5/8 Girdle - SOLD
Fuel rail and all lines - $100 plus shipping
Alternator $100
Front housing and cover -SOLD
Trans adapter - $100 plus shipping
 
This is what I have left. Wanting it all gone this week. Ready to deal.
Carrillo Rods: $2,000 shipped
Monotherm pistons(.020) - $2,000 shipped
Haisley cast cam - $400 shipped
Alternator $100
Trans adapter - $100 plus shipping
Trans Blanket for 48re Suncoast - $200 plus shipping
 
Pm sent. As well as bump for a good seller

Sent from my SM-G900P using Tapatalk
 
I will drop the rods and Pistons a bit:
Carillos - $1800 shipped
Monotherms - $1800 shipped
 
You must log in or register to reply here.
Top