1st gen

[1stgencummins17]

i am in the middle of p pumping my 1st gen an i am kinda stumped on how to set up the fuel return from the pump an the injector return line if anyone has pics that would be a big help ive searched an searched an couldnt find anything helpful

 

[rockjeep73]

Just get a brass "T" fitting and some rubber fuel hose and T the two together and hook it up to the factory return line. You will have to cut the end off of the injector return line so you can slip a rubber hose over it.

 

[1stgencummins17]

ya i went to napa today got a t an 5/16" hose an sum barb fittings to go into the t cause it was a female t looks good see how it works wen i get it back together

 

[FIRST GEN. JAKE]

are you talking about going from the soild metal line to the plastic fuel line? when i did mine i used compression fittings to hook them together. as far as the return from the injector i had a return line off a sencond gen where it has a banjo bolt that threads into the top of a bigger bajo from the lift pump on top of the filter housing. hope this helps