mech2161
I have a secret.
- Joined
- Jan 15, 2007
- Messages
- 3,986
Here's what is on the NADM site.
Turbocharger: The vehicle is limited to a single turbocharger; the inducer bore on the
compressor housing may be 2.6”. The inlet will be measured using a 2.65-inch plug or internal
calipers. Bushing from any larger turbo size down to a 2.6 turbo is PROHIBITED. A stock
map width enhancement (MWE) groove is allowed. No MWE groove will be allowed that has a
width greater than 1/4 inch. All provisions allowing air to the wheel other than via the bore and
the MWE groove are prohibited. 6.4 liter Powerstroke engines may utilize the factory twin-turbo
configuration.
I don't see that here.
http://www.competitiondiesel.com/forums/showthread.php?t=40786
Turbocharger: The vehicle is limited to a single turbocharger; the inducer bore on the compressor housing may be 2.6”. The inlet will be measured using a 2.65-inch plug or internal calipers. A stock map width enhancement (MWE) groove is allowed. No MWE groove will be allowed that has a width greater than 1/4 inch. All provisions
allowing air to the wheel other than via the bore and the MWE groove are prohibited.
6.4 liter Powerstroke engines may utilize the factory twin-turbo configuration.
Turbocharger: The vehicle is limited to a single turbocharger; the inducer bore on the
compressor housing may be 2.6”. The inlet will be measured using a 2.65-inch plug or internal
calipers. Bushing from any larger turbo size down to a 2.6 turbo is PROHIBITED. A stock
map width enhancement (MWE) groove is allowed. No MWE groove will be allowed that has a
width greater than 1/4 inch. All provisions allowing air to the wheel other than via the bore and
the MWE groove are prohibited. 6.4 liter Powerstroke engines may utilize the factory twin-turbo
configuration.
I don't see that here.
http://www.competitiondiesel.com/forums/showthread.php?t=40786
Turbocharger: The vehicle is limited to a single turbocharger; the inducer bore on the compressor housing may be 2.6”. The inlet will be measured using a 2.65-inch plug or internal calipers. A stock map width enhancement (MWE) groove is allowed. No MWE groove will be allowed that has a width greater than 1/4 inch. All provisions
allowing air to the wheel other than via the bore and the MWE groove are prohibited.
6.4 liter Powerstroke engines may utilize the factory twin-turbo configuration.