sideways76
New member
- Joined
- Jan 22, 2018
- Messages
- 9
The trans will go in reverse, neutral and drive but I feel like I only have 2 gears. Since this is a cummins is in the ford, the indicator is different from the actual gears and I am new to the truck. I feel like it stays in 3rd like its in limp mode. I can gear down once to take off, and manually shift up once.
Tranny is - 2003 2wd 48re Built by Darren Morrison with DPC Converter, Billet Input and Intermediate and Suncoast VB.
I am getting these codes and was uncertain if any of these came with the swap into the F-250? I never have done a swap and didn't know if any of these were because of the swap and I can just move to the next. We have went through and checked all the fuses and found some wires that were loose connections. We fixed any loose connections we found and replaced some fuses.
These all were read with my Smarty.
P2769
P0973
P0480
P0500
P0628
Any info or guidance on where to start would be greatly appreciated!
Tranny is - 2003 2wd 48re Built by Darren Morrison with DPC Converter, Billet Input and Intermediate and Suncoast VB.
I am getting these codes and was uncertain if any of these came with the swap into the F-250? I never have done a swap and didn't know if any of these were because of the swap and I can just move to the next. We have went through and checked all the fuses and found some wires that were loose connections. We fixed any loose connections we found and replaced some fuses.
These all were read with my Smarty.
P2769
P0973
P0480
P0500
P0628
Any info or guidance on where to start would be greatly appreciated!