Mark Nixon
No Savior among the flesh
- Joined
- Feb 26, 2009
- Messages
- 8,678
Hard to imagine you this confused over something so simple, biggy.
Mark.
Mark.
How does it act?I am currently running 6.7 injectors in a 5.9 head, the top of the Injector bore and also the area were the hold down bolts need to be machined down about .100-.120 for a completely unmodified 6.7 injector and holder to fit correctly in a 5.9 head.
If you only machine the bore then you have to modify the hold down. If you don't machine the bore the injector will not seat to the bottom of the bore and you will have a bunch of compression in your return line.
How does it act?
Sent from my XT1575 using Tapatalk
I had already decided a single event was the way to go with a CM849. Good to hear from someone running them.Fires up with a little puff of white and I had to go single event to make them run good but they are 550%'s so hard to say how a smaller injector would act.
They defiantly make power though, went 8.85 at 158.89 on fuel @6k pounds.
What ECM are you firing them with Phillip ?
Factory 06 ecm that came on the truck
Thanks man, that's what I figured. There are LOTS of people out there that swear you can't run 6.7 Injectors on a 5.9 ECM... Even when it's been proven that you can.
Would that be less timing for them or more for the 70hp.