6 lug rims fit the "OEM axle" rule?

I read it as the housing and parts(hubs, brakes, ect.) has to be for 1 ton or smaller rockwell hubs are not 1 ton or smaller, but im just putting out my opinion. It doesnt say you cant so i guess you can or not
 
Still a OEM style hub as far as fitting the OEM spindle using OEM bearings and seal. Would be machined for the 6 bolt drive as well as utilizing a different brake setup

Only difference in essence would be the bolt pattern on the wheel
 
dmaxalliTech said:
Still a OEM style hub as far as fitting the OEM spindle using OEM bearings and seal. Would be machined for the 6 bolt drive as well as utilizing a different brake setup

Only difference in essence would be the bolt pattern on the wheel
Click to expand...

I was under the impression you were trying to use 106 hubs. If you were to use the 80 hub and machine a flange to accept the 106 studs i dont see an issue
 
go for it eric, if they ***** just ask them what one ton dana 80 or 11.5 had 40 spline axles oem.
 
You must log in or register to reply here.
Top