810/1427 Single turbo w/H2O 06'

He's got 100hp sticks. The kicker to this is that the walbro on this truck was dropping to 0 at WOT and rail pressure was still holding at 25k psi. I can't wait to see what this truck will do with fuel pressure and holding the rpm's out to 4000. Should be exciting.
 
All Hamilton cams, pushrods, and spings are his own . They are sold by several vendors in this buisiness but they were designed and built by Zach Hamilton. I've run two of his cams in my 02' and settled on one that fit my needs, and he paid for the dyno time. I guess I was the first beta tester to give any real feedback. The other beta units went in to race and pull trucks that no-one quite knows how much power is made. If you pay close attention there are HD cams in several mean trucks here in Texas and all over the U.S. and his new springs are everywhere.

Jared
 
:evil Brett from II thinks we might be winding the SPS 64 alittle to tight.:ft:
 
its common knowledge on dual cp3 trucks that 2 walbros are needed...or a Airdog 150 or FASS 150.

i heard about the little bit more air plans LOL
 
Hmm. 2 walbros or 1 fass pump. I wonder why......;)

Yeah. I heard about the little bit more air plans to. LOL
 
Just trying some diferent tuning got it back on the dyno Wed. and backed it up with a 739hp 1396tq on #2 only no water with the SPS 64
 
What was the tunning this time? I have been hearing good things about hamilton diesel as well.
 
JaMan said:
:Cheer:Just heard the news Ramario Salazar just made 684/1458 on #2 and 810/1427 with 60/40 H2O on the Dyno at Alvarado, Tx. on a single turbo truck. A 64/14 turbo that is. Who says you can't make good power on a single with out spray. Incredable... Made several runs in the 790's as they adjusted the water and toped it off with a 810 run. Not bad for a truck built in a little podunk shop in McDade, Tx.:rockwoot::rockwoot:

Jared
Click to expand...

I had a feeling that my little 64 is capable of near 700. I've been thinking of water based on all these melt down theads.

However and extra 130hp on water is flat out awesome. Who's water kit? Spe s on that please.

Also what kinda boost numbers was this truck running on and off the water?

What kind of cac as well
 
thats nuts, spinning the 64 a lil too tight? what kind of psi ya squeezin out of it ? and like above, whose water setup, nozzle count/ size...... share the wealth of knowledge !
 
50 psi fuel 55psi with the water. This is from nearly 1.5 years ago, just trying to show the naysayers from the other Single Turbo CR thread.

Jared
 
JaMan said:
50 psi fuel 55psi with the water. This is from nearly 1.5 years ago, just trying to show the naysayers from the other Single Turbo CR thread.

Jared
Click to expand...

Interesting. I've been told the 64 wheels are generally inefficient over 45.
 
You must log in or register to reply here.
Back
Top