CAT Doc
New member
- Joined
- Oct 7, 2006
- Messages
- 23
Just got the module installed and now I have no egt's, and no oil temp, and no boost going down the highway, I have checked grounds changed locations of them and the power also, hit a bump in the road and then you have egt's and oil temp. but still no boost, I have mechanical gauges so I have some boost psi and egt's, cannot get the remote to change from PL00, all at once the remote will change to PL01, I have had it to PL07, but I know it isn't fueling, the little remote pod will loose light segements, shake the remote and it will light back up, key off and it resets back to PL00, wondering if the wiring harness has a wiring pin in the wrong location, if you look at the .pdf on installation it shows the data link to be the connector with 3 wires and the map to be the connector with 2 wires but installation instructions shows opposite, a schmatic with pin locations would help. I have flashed the module to ADR2000 no help, flashed it back to ADR1000 and no help, back on ARD2000 now. HEP ME :bang