roachie
Taco Master
- Joined
- Nov 2, 2007
- Messages
- 11,133
Im going to a 5" inlet charger and cant use this one its a 4". Can get the over all measurements if needed. has a few scratches from riding in under the backe seat.
I built it all from scratch, epoxy primed it to prevent rust, all the fasteners are stainless steel with lock washers. It can be disassembled if needed, has foam tape sealing everything together. I even sealed the welds just to make shure. Should be about 90% dust proof. I have a release cables for the cab and one that runs about 5ft to connect to another that runs to the bumper (not included). Release handle is painted with red candy.
$150 firm shipped.
[/IMG]
[/IMG]
And thes HSG's said you want it.
[/IMG]
Link with more pictures:
http://www.competitiondiesel.com/forums/showthread.php?t=32560
I built it all from scratch, epoxy primed it to prevent rust, all the fasteners are stainless steel with lock washers. It can be disassembled if needed, has foam tape sealing everything together. I even sealed the welds just to make shure. Should be about 90% dust proof. I have a release cables for the cab and one that runs about 5ft to connect to another that runs to the bumper (not included). Release handle is painted with red candy.
$150 firm shipped.
And thes HSG's said you want it.
Link with more pictures:
http://www.competitiondiesel.com/forums/showthread.php?t=32560
Last edited:
