Any tips for installing engine?

Sounds good. Trying to get a list of things needed for the job, getting prepared ahead of time is the key I think. I just went out and started spraying down all the bolts with PB blaster.
 
If your doing it on the floor, sometimes its easier to unbolt the bell housing from the tranny and pull it out with the motor. Its easier to take those four bolts out then the six on the motor. It also helps with the extreme angle you need cause the tranny can now be tilted higher if the bell housing isn't hitting the floor. Just my $.02
 
You must log in or register to reply here.
Back
Top