New Castle Info
Wes, what classes are at New Castle and Cynthiana. What time do they start, what are the addresses, what's the payouts, and do you have to join an association? Any information would be appreciated. Thanks, Jon
3rd Annual
New Castle Lion’s Club
Truck and Tractor Pull
Henry County Fairgrounds U.S. Hwy 421
New Castle, KY
Admission ~ $8.00
May 15 &16
Pulls Start @ 7:00 P.M. Sharp
Friday May 15 Prize Per Class
8,000 lb. Daily Driven Diesel 4x4 Trucks (No Hanging Weights) $500 & Trophy
8,000 lb. 2.6” Turbo Diesel 4x4 Trucks $1000 & Trophy
8,000 lb. 2.8” Turbo Diesel 4x4 Trucks $1000 & Trophy
8,000 lb. Open Diesel 4x4 Trucks $1200 & Trophy
Entry Fee $30.00
For Information or Rules Contact
Justin Atchison (502) 664-1129
Anthony Mahoney (502) 817-5488
Henry County Cattleman’s Association to Provide Concessions
Not Responsible for Accidents
Judges Decisions Are Final
Diesel Trucks
1. Trucks may be hauled to the pull
2. All trucks entering any class other than Open shall utilize a single turbocharger.
3. Daily Driven trucks must utilize OEM turbocharger. 2.6 inch trucks are not allowed to downsize the compressor housing with bushings or slugs, turbo to be checked with a 2.65 inch plug. 2.8 inch trucks may use slugs or bushings to downsize the compressor housing ahead of the wheel but, must meet the 2.8 inch I.D. at least ž inch in front of the wheel along the bore. A stock MWE groove is allowed. No MWE groove will be allowed that is greater than ź inch. All provisions for air entering other than the bore or MWE groove is prohibited. Adapter plates are allowed except for the Daily Driven Class.
4. All computer chips and boxes are permitted.
5. No Nitrous, Propane or CNG
6. Water/Methanol Injection is not allowed.
7. There will be underhood inspections
8. Rear suspension may be blocked. Blocks must be easily removed. NO WELDED REAR SUSPENSION.
9. Air bags permitted, must have only one airline running to them and line must be capped off, no air tanks, compressors or in cab controls.
10. Except for the Daily Driven Class front hanging weights are not to exceed 60 inches forward of the center of the front axle. This will be measured from the center of the front wheel. Weights must be mounted as to allow for the crossing of the scales without the weights hitting the scales.
11. No weights in the cab of the truck.
12. Factory or commercially distributed aftermarket hitch. Must be horizontal to the ground and stationary in all directions. Height of hook point shall not exceed 26 inches from ground. Minimum 3 ˝ diameter for sled hook (NO UNDERBED PULLING HITCHES).
13. Hook point must be past the rear of bed.
14. NO hitches with a chains holding to a gooseneck ball or other device in truck bed.
15. NO weight transfer hitches.
16. No chains, studs or spikes, ect.
17. DOT Street legal tires only.
18. Engine must have came stock from the factory in a 1-ton or less pick-up truck. Engine does not have to match body(i.e. Cummins engine in a Chevy or Ford)
19. Drivetrain must be OEM from 1-ton or less pick-up(No Drop Boxes or Reversers)
20. Rear axle bolts must be covered by center cap or shield.
21. Drivers must wear seatbelt & helmets are recommended.
22. IT IS STRONGLY ADVISED THAT ALL TRUCKS HAVE SAFETY EQUIPMENT (FUEL SHUT OFFS, KILL SWITCHES, SCATTER BLANKETS FIRE EXTIGUSHER, DRIVELINE LOOPS, ECT.)
OPEN DIESEL TRUCKS
1. Engine must have came stock from the factory in a 1-ton or less pick-up truck. Engine does not have to match body(i.e. Cummins engine in a Chevy or Ford)
2. Height of hook point shall not exceed 26 inches from ground. Minimum 3 ˝ diameter for sled hook.
3. Front hanging weights are not to exceed 60 inches forward of the center of the front axle.
4. And all other safety rules apply.
5. Open means Open