BD Fall Dyno Days

[Smokin07]

Here are a couple of clips from BD.
I don't have the numbers, but thought you might enjoy a few some visuals!

Onetun (Rob) 870+Hp
http://videos.streetfire.net/video/Ontetun-Dyno-Run_194502.htm
Nice run Rob! Sorry to run away....I had had to get the truck home.
Will buy at the Keg next time!



24Vchevy (Malcolm)
The Dyno only showed 760 or so, but the power is pretty obvious!

http://videos.streetfire.net/video/Malcolms-BD-run_194506.htm

Will post more with some pictures when I get a chance.

 

[metal_miner]

How did you do?

 

[luvinacummins]

hmm i would have though rob would have hit alot higher?? deffinately a good number and nothing to be ashamed of...:rockwoot:

 

[24VChevy]

How did you do?

We had a head gasket issue with Jamies truck. It blew out the center out of the MLS on #1. Compression was leaking out right by the front center head stud. Never seen that before. We have been chasing a unusual sound for a while. We could have run it but did not want to risk damaging the block or head surface.

Thanks for posting the Video's Jamie.


Malcolm

 

[bh10]

24Vchevy (Malcolm)
The Dyno only showed 760 or so, but the power is pretty obvious!

http://videos.streetfire.net/video/Malcolms-BD-run_194506.htm

Will post more with some pictures when I get a chance.

WOW, that thing sounded wicked :rockwoot:

 

[Smokin07]

I'm sure Onetun will get some more ponies dialed in....Rob just needs some more time to dial his setup.
It should also be mentioned that BD's dyno is a difficult one to make power on...The roller is almost glass smooth.

There were a few sad faces in our camp....We really wanted to hook the truck and give it our best shot.
As 24vchevy mentioned we had an intermittent sputtering noise that turned out to be a defective MLS headgasket...I made the sad discovery on the drive over.....That's how it goes sometimes! :bang

We will go at it again in the spring.