NickTF
Single turbo turd.
- Joined
- Jun 4, 2007
- Messages
- 5,887
Did the 2nd hot torque yesterday on them and continued to loose some lash. After my experience with this so far I just can't see how stock head bolts torqued one time cold would allow the o-ring of the head press into the gasket as well as a few hot torques via studs.
The number 5 rocker stud still is acting a bit funny but for now i'm calling it good as i did get it up to 115ft-lbs hot.
Also through back in some 181s and man I miss how smooth they idle! :rockwoot:
Hoping I can intersecpt my down pipe at a UPS depot close around the weekend so I can get the new ED 362 on. Right now it's showing is not getting delivery until fricken October 20:doh:
The number 5 rocker stud still is acting a bit funny but for now i'm calling it good as i did get it up to 115ft-lbs hot.
Also through back in some 181s and man I miss how smooth they idle! :rockwoot:
Hoping I can intersecpt my down pipe at a UPS depot close around the weekend so I can get the new ED 362 on. Right now it's showing is not getting delivery until fricken October 20:doh: