Cummins EM on a dt 360

jimdawg185

jimdawg185

New member
Joined
May 9, 2009
Messages
105
I have read a couple of posts on oddball forums about a 5.9 common rail exhaust manifold fitting with a little "help" on a dt 360 motor. As well as a milled 5.9 intake working with new holes drilled on the intake side. Im prolly gonna tig up my own, but this would save me some time for sure.
 
So...
Are you asking if its true that they work or???

BTW- I'm very jealous of the swap your doing!
 
yes with some massaging they work very well. Is this going into a truck or tractor
 
didn't know if it was going on a tractor, i think to get the exhaust pipe holes to to line up it takes a little work

but thats not a worry with an excursion
 
You must log in or register to reply here.
Back
Top