Drive shaft loops

chrisf97305

chrisf97305

New member
Joined
Jul 13, 2008
Messages
24
Does any one have some good pictures of drive shaft loops. I drive my truck on the road all the time so it has to be clean and tough. Don't want it to fall off driving down the road.
Got any good ideas??
 
Joe Hellmann built mine. I don't have a carrier bearing, so we used thoses mounting holes and he bent a 1" round bar into a U. Simple and works like a charm.

Give him a call. I'm sure he can wip something up for you pretty quick.

http://hellmannperformance.com/
 
Hellmannperformanceloop.jpg


Not the greatest. This is the front driveshaft loop. The rear looks pretty much the same, but it is a little taller.

Just call Joe and talk to him. Great guy to know and work with.
 
The HD Fab loops are nice if you don't need shields for pulling (those are in the works)

Awesome work, stout design, bolt right up with no drilling or shimming.
 
And I just noticed you have a Ford:bang

Aaron doesn't have any Ford stuff out. Yet.
 
I need you-joint shields for pulling. Looking for something small and strong. I drive my truck as a dialy driver.
 
You best bet would be to make something removeable. I have mine that way so I can just unbolt it and be on my way. I drive alot and just pout it on when its needed.
 
Very nice Scott. How long did it take to remove them if you needed to make any repairs to the driveshaft?
 
You must log in or register to reply here.
Top