For Sale

Pump was built by Cincinnati Diesel Injection around 550-600cc fuels hard higher than it needs too. When my stock driveshaft broke I saw 5800 as peak from my tach. The DHD is currently set up for a manual but I have the input gear to change it over to an auto if you want it.
 
dshawhan said:
Pump was built by Cincinnati Diesel Injection around 550-600cc fuels hard higher than it needs too. When my stock driveshaft broke I saw 5800 as peak from my tach. The DHD is currently set up for a manual but I have the input gear to change it over to an auto if you want it.[/QUOTE
Switching from DLD to DHD would i have to change drive shafts? or the trans output or transfercase input/ output?to make it work? thanks.
Click to expand...
 
Yes I still have the pump it is not a 911 or 913 it is an early model I think 854 has big DV's and holders mack plug lightened weights 4gsk will hit mid to high 5k's if you let it. plate is a "0" plate. To make a DHD replace a DLD front yoke on rear driveshaft needs changed other than that nothing. DHD is about 3/4 of an inch longer but most driveshafts don't need shortening. Slip yokes have enough give already. if interested let me know, thanks Dan
 
how big of a difference is there in the blankets between 5600 and 4500. Can a guy make the 5600 blanket work for a 4500??????
 
The check is in the mail for the rear end gears & the 5600 blanket, let me know when you send them so I can expect it. Thanks
 
Update:

Motor is spoken for waiting on money to say it is sold for sure should know this week.
Trans is sold, clutch is sold, Rear end sold, Rear carrier and blanket sold, 100 psi boost and pyro sold,

Still have:
1. Dana 60 w/3.54 gears complete $1000
2. DHD t-case $750
3. DLD t-case $400
4. Injectors Schied 6x.022" $800
5. Connector tubes drilled out $80
6. ECM for 99 manual $400
7. PCM for 99 manual $100
8. PCM for 97 auto new! $400
9. Front driveshaft for 6spd needs new u-joint at axle $100
10. Rest of truck will be parted out also from das pieces to headlights and taillights if interested in anything like that pm me for info.
 
Sorry manifold went with engine. Still have all kinds of parts if anyone is interested pm me
 
You must log in or register to reply here.
Back
Top