Fuel line suggestions!

S

swamp_ratt

Snootchie Bootchies
Joined
Jan 14, 2011
Messages
281
Getting close to firing up my project for the first time. Running a dt360 with a p7100 fed by an aeromotive a1000 and a torktek regulator. Will be using the Baldwin filter bases with cat filters. Wondering what to do for all my lines and fittings. Want to run 1/2 inch supply lines. Advice/insight appreciated
 
Steel tubing for long runs and AN fittings and ss braided lines for the short runs.
 
I like to use eaton synflex plastic line.. I ran 1/2 feed and 3/8 returns using it. I like the Fleetguard filter bases too . i recommend putting 2 ball valves in on both sides of your filters so you can shut them during filter changes, or egine work so your prime isn't lost. could also be a antitheft thing too lol.
Thanks,
Deo
 
I use pushlock stuff with the fragola ends and there crimp clamps. Seen 120psi with no problems.

from phone
 
You must log in or register to reply here.
Top