Full Built pull/race LB7 Motor

[gainer16]

This is a custom fully built lb7 pull/race motor. Here is some info on it...

Carillo Rods
Mahle Forged custom cut pistons bored .40 over
girdled
arp main and head studs
socal stage 2 heads
glow plug deletes
titanium bridges
chromoly push rods
billet injector hold downs
max rev kit
all been balanced
keyed crank
socal cam shaft
ats flex plate
socal super damper
ats dual cp3 with modded lbz pump
modded lbz pump in the valley
new water pump middle of 2010

the motor was fresh with a new block and crank the beginning of the 2010 pulling season. also had new main, rod, and cam bearings as well.

Motor was built by Mark Broviak at Danville Performance and myself.

Will sell with injectors and turbo which includes rick d'lance headers and up pipes. Turbo is an S480 that only has 3 hooks on it and the injectors are custom exergy engineering.

$28,500 with out injectors, turbo, and manifolds

$35,000 complete

any other questions feel free to ask

 

[gainer16]

bump

 

[gainer16]

still up forsale....

 

[sleeperman]

Why are you selling it? What are you going to build next?

 

[01silver bullet]

Have you dynoed this?

 

[gainer16]

at 3800 rpm it made 910 on the dyno at the wheels with a 2.6 charger on it with all the load the dyno could throw at it. with this being said im very confident this is a 1000 hp 2.6 motor due to the fact there was no where near enough load. anything bigger of a charger you would just go up from there.

i am selling to do some kind of different project....not being sure what that is though. just need to sell first to be able to decide what i can do.