Ram12vcummins
New member
- Joined
- Mar 17, 2015
- Messages
- 1,659
Pulled a 12v from a 97 ram 2500. Unfortunately found out the pump is no good. The motor will be going into a massey harris 55 tractor for using at our antique tractor pulls. Nothing too crazy. Needing some parts and constantly searching. Might be a slow build. Haven't done much for fab work and building. Here's the start.
Just a shot of motor over the tractor.
Going to need to figure out how to make a clutch setup with a output shaft.
I have been given a crowerglide triple disc clutch that bolts to a big block hemi crank so the pattern doesn't match. Was contemplating machining a stock cummins flywheel and swapping it out for the back of the crowerglide aluminum flywheel. Will get some pics of clutch up right away.
Just a shot of motor over the tractor.
Going to need to figure out how to make a clutch setup with a output shaft.
I have been given a crowerglide triple disc clutch that bolts to a big block hemi crank so the pattern doesn't match. Was contemplating machining a stock cummins flywheel and swapping it out for the back of the crowerglide aluminum flywheel. Will get some pics of clutch up right away.