OnVacation
New member
- Joined
- Apr 26, 2011
- Messages
- 381
I'm looking at building a hybrid H1C/H1E hybrid for my 12V to save some coin during the rebuilding. planning on mating it up to my HX60 for a set of twins. I've read that the hybrid is made by pulling the backing plate, compressor wheel, and housing off of the H1E and putting it on the H1C. the H1E I'm looking at is fresh off a rebuild with a good CHRA. is there a reason that I couldn't use the CHRA from the H1E and just swap over the shaft, turbine, and turbine housing from the H1E and use the fresh bearings from the H1E?