HMR or SCS?

Z

ztdamico

Cummins Fan
Joined
Oct 5, 2007
Messages
27
HMR or SCS?

Who makes a better axle,full spool,and mini spool?

Also anyone ever run HMR Front and Rear Drive Shafts With the 1480 Slip Yoke?

Worth the money?

Who Else Makes These componets?
 
I would run hmr rear shafts, full spool. I would run E.M.S. offroad front shafts 35splin. 1480 rear driveshaft and 1410 front drive shaft. Check your local catco or driveshaft store they can set you up. AS for yokes catco or a driveshaft store should be able to set you up if not hmr has them too.
 
Roe Truck in Indiana can make the shafts. If you want turn key you can go to haisley.
 
the axles that haisley sells are the best i twisted 35 spline scs's get the 37 HMRs and full spool about any driveshaft shop can make driveshafts just make sure you tell them what you want. the 1410 holds just fine behind the 241 if you change to the 271 transfer case you can put the 1480 in it but both hold fine for the front joint, of course 1480 in the back
 
You must log in or register to reply here.
Top