Hp and mods??

DieselP

New member
Joined
Jun 2, 2013
Messages
63
02 ppump 24 215pump 32degree timing
F1 Mach4s, 93 lines and tubes, pump benched at
1000cc, 62 compounded with a 74, wondering where
I could be in hp?? Iv broke 2 front drivelines, billet output,
One intermediate, and just twisted the splines on my
Billet input?? I didn't figure I would have enough power to
Do this??
 
What are you doing when you break this stuff? Driving, racing, sled pulling?
 
It is very overfueled no doubt about that.
It's almost raw fuel coming out the exhaust
When trying to spool. And the truck is just a race
Truck, I'm fixing to sell these chargers for a bulleye
S475 87/1.10 t4 and spraying it and eventually
Compounding with an s510, but not 100% sure yet,
Any tips appreciated!
 
Dually everytime iv broke is on the trac, two weekends ago on
My 3/4 shift I snapped the intermediate, I pulled it apart last
Weekend and noticed I twisted the splines one the input as well,
Then I had to use an air hammer to get the intermediate out of the
O/d unit because the splines were twisted as well...
 
What are your ETs at the track? That will tell you your HP. Any shock loading?
 
I haven't got to make a full pass since I cranked the fuel. I had the fuel turned down and ran a best of 11.4 at 115ish on 35s truck weighing 7800
 
yes this last run I put 265s on it changed gears to 3.55, dropped the tank for a fuel cell, and took a lot of the crap off I didn't need. I didn't make a full pass I broke the trans about 35ft before the 1/8. still ran a 7.5 in the 1/8 and my 60ft was a 2.040 (white smoking 4 tires).
 
02 ppump 24 215pump 32degree timing
F1 Mach4s, 93 lines and tubes, pump benched at
1000cc, 62 compounded with a 74, wondering where
I could be in hp?? Iv broke 2 front drivelines, billet output,
One intermediate, and just twisted the splines on my
Billet input?? I didn't figure I would have enough power to
Do this??

assuming you have a 13mm pump...i cant believe you are just running a 150hp inj.
 
I have an Opie intermediate for sale! sorry I can't give you an idea on hp level… I'm a wires guy
 
Back
Top