Billy Stocklin
New member
- Joined
- Mar 10, 2011
- Messages
- 115
What are the fittings and what type of machine would it take to make the lines/ fitting assemblies in hard line. I like the look of the new motorsport diesel lines.
http://www.motorsportdiesel.com/storename/motorsportdiesel2/Image-10799438.aspx?
seems like you could make some trick stuff that cleaned up the engine bay. Especially in dual cp3 setups, side intake setups, custom injector lines, dual feed line setups or any combination of the above.
I've asked around a little and no one seems to be accomidating. What would it take to make your own and where would you get the bender/ whatever kind of goofy special flare tool that is/ and materials/ fittings to do this?
http://www.motorsportdiesel.com/storename/motorsportdiesel2/Image-10799438.aspx?
seems like you could make some trick stuff that cleaned up the engine bay. Especially in dual cp3 setups, side intake setups, custom injector lines, dual feed line setups or any combination of the above.
I've asked around a little and no one seems to be accomidating. What would it take to make your own and where would you get the bender/ whatever kind of goofy special flare tool that is/ and materials/ fittings to do this?