schaef_12
Diesel Junkie
- Joined
- Oct 30, 2007
- Messages
- 248
Ok, I just bought a set of new 350 Marine Injectors with 2 flows on them (around 68 LPM) with the pop off set to 300 BAR. After Installation, I have a weird part throttle flutter that I am assuming is a timing issue. The pump is set at exactly 16*. I guess my question is what amount of timing (in degree's) should I be running to get these injectors to act right? Ie: keep them in them spraying in the bowl?
I was thinking 18* would be a good place to start as I would like to run around 3800 rpm.
Mods are P&P head, Firering, Helix II, Valve Job, yadda yadda. 4k and a 100 plate.
P.s. When setting the Valves should I stick with stock specs even with the Helix II?
Thanks
Corey
I was thinking 18* would be a good place to start as I would like to run around 3800 rpm.
Mods are P&P head, Firering, Helix II, Valve Job, yadda yadda. 4k and a 100 plate.
P.s. When setting the Valves should I stick with stock specs even with the Helix II?
Thanks
Corey
Last edited: