SPEEDSHIFT
New member
It steers! Just need to extend the column a little and finish weld/box the front axle.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Looks good man! Messaged ya a few times on insta. Cruised over here to give your build a follow also.
If ya dont mind me asking what is all done to your 03. Have you dynoed your current setup. Whats it weigh. Sorry for all the questions and derail
Single FI 485/96/1.15 T4
135% DDP Injectors
dual CP3s
188/220 Hamilton Cam
2800 stall converter and built trans
Truck weighs about 6500lbs, and I have never dynoed it. The ET calculator put it at 1150 I think with the 10.34, but that wasnt a great run as it fell off the turbo in OD, thats why MPH was only 128. I think it has low low 10s on fuel in it, and maybe a high 9 on a small shot nitrous.
You going to be running the same fuel / air setup in the new build?
What will you be running for a datalogger? Ive been trying to look into different setups than a Edge CTS 2 like everybody else lol...
I will probably just upgrade my HP Tuners cable to a Pro so I can log drive pressure and EGTs. Maybe later on I will get something better.
Looking good man! This is a great thread!