Jeffrey Weeks
New member
- Joined
- Dec 1, 2016
- Messages
- 183
I’m going to post this build thread because i didn’t see much information on this. I’m halfway into the swap.
Truck is a 1996 ram 2500 12 valve ECLB nv4500 2wd.
Parts you have that will work:
- The engine adapter plates are the same for all the transmissions 94-98
- Bell housing bolts
- Throttle bracket on the p7100 has the TV cable port and lever/connector for tv cable end
- I do believe a tps can be mounted (I’ll look and verify)
Parts you will need:
- 47rh transmission
- Flexplate
- Torque converter
- Dipstick & tube
- TQ converter bolts QTY (6) 3/8 - 24 x 5/8
- Flex plate bolts (to crank) QTY (8) thread is M12x1.25 (not sure on exact length)
- Tv cable (unless manual VB or zip tie tv lever back)
- Steering column for shifter (I’m using a rachet shifter) B&M Z Gate
- PCM & TPS (for overdrive and lockup) or toggle switches or hobb switches
- Driveshaft from automatic truck (47re has same slip yoke and both transmissions are the same length about 37” inches long.)
- ATF +4
- Transmission cooler
- Transmission fluid lines
I will update this as I go. If I left anything out I will add it later on. I will instruct how to wire switches for overdrive and lockup. Im looking forward to this project.
Sent from my iPhone using Tapatalk
Truck is a 1996 ram 2500 12 valve ECLB nv4500 2wd.
Parts you have that will work:
- The engine adapter plates are the same for all the transmissions 94-98
- Bell housing bolts
- Throttle bracket on the p7100 has the TV cable port and lever/connector for tv cable end
- I do believe a tps can be mounted (I’ll look and verify)
Parts you will need:
- 47rh transmission
- Flexplate
- Torque converter
- Dipstick & tube
- TQ converter bolts QTY (6) 3/8 - 24 x 5/8
- Flex plate bolts (to crank) QTY (8) thread is M12x1.25 (not sure on exact length)
- Tv cable (unless manual VB or zip tie tv lever back)
- Steering column for shifter (I’m using a rachet shifter) B&M Z Gate
- PCM & TPS (for overdrive and lockup) or toggle switches or hobb switches
- Driveshaft from automatic truck (47re has same slip yoke and both transmissions are the same length about 37” inches long.)
- ATF +4
- Transmission cooler
- Transmission fluid lines
I will update this as I go. If I left anything out I will add it later on. I will instruct how to wire switches for overdrive and lockup. Im looking forward to this project.
Sent from my iPhone using Tapatalk