kansasfirstgen
New member
- Joined
- Mar 11, 2011
- Messages
- 234
I didn't trust one turbo off of 1/8 npt..the threaded hole doesnt look that small but you should look at the id of a 1/8 npt jic fitting. it is scary small
You think 1/4" would be sufficient for both turbos?Or you could tap to 1/4 npt and run a tee to feed both turbos, then just plug the other port
Or you could tap to 1/4 npt and run a tee to feed both turbos, then just plug the other port
That's what I was thinking 3/8" to be safe.Yeah, I would drill out the inside of the tee though so there is no restriction-- "port" the fittings lol. There is enough material there to drill and tap the aluminum to 3/8 though if you are worried.