NakeDiesel
Smoke'n in the Mud
- Joined
- Jan 20, 2010
- Messages
- 1,116
Been a busy two days here at the shop. Where to start...
The bedsides have been painted and put on the truck.
Radiator is installed and the water lines all hooked up and ready for water.
Trans coolers are mounted but need to get some 90's for them.
Fuel cell and fuel pump are mounted. Just need to drill the holes in the floor to run the lines under the bed.
Rear portion of the diamond plate is cut and put as well as the spaces to fill the gap between the shocks.
Shut off switch is mounted in the rear.
Brake booster rod has been cut off and shortened 1 1/2 inches
Brake pedal installed
Wiring run for everything in the engine bay
Hose clamps installed on hydraulic return lines
Grill primed inside and out
Hood primed inside and out (needs bodywork on some dings)
Battery support bars primed and painted
Rear bed braces primed and painted
Rear fenders painted
Rear fenders braces installed
Tomorrow I plan to do the body work on the hood so I can get it and the grill painted, finish figuring out the throttle and do some more wiring on the truck.
The bedsides have been painted and put on the truck.
Radiator is installed and the water lines all hooked up and ready for water.
Trans coolers are mounted but need to get some 90's for them.
Fuel cell and fuel pump are mounted. Just need to drill the holes in the floor to run the lines under the bed.
Rear portion of the diamond plate is cut and put as well as the spaces to fill the gap between the shocks.
Shut off switch is mounted in the rear.
Brake booster rod has been cut off and shortened 1 1/2 inches
Brake pedal installed
Wiring run for everything in the engine bay
Hose clamps installed on hydraulic return lines
Grill primed inside and out
Hood primed inside and out (needs bodywork on some dings)
Battery support bars primed and painted
Rear bed braces primed and painted
Rear fenders painted
Rear fenders braces installed
Tomorrow I plan to do the body work on the hood so I can get it and the grill painted, finish figuring out the throttle and do some more wiring on the truck.