I've been doing a lot of research into the whole CF process and talked to Randy at OSF as well about it. I plan on doing vacuum infusion for my parts. The layup I'm looking at using is single layer of 3k CF, layer of 2mm Baltek Mat, and single layer of 3k CF.
Will need to build an aluminum frame support for the grill to support the hood end on the nose side and aluminum brakets to mount the front fenders. Looks like a good time to buy a tig gun setup for my tweco multiprocess welder.
I will make molds off of the existing parts I have, but want to shrink both the front and rear fenders to make them smaller and stick out less. They don't keep mud off the truck anyway, but have to technically have fenders in classes I run in, if I didn't, I wouldn't have the fenders on it in the first place.