Redneck Porn

[paulb]

Jeff (Snedge) sent me a couple of pics and labeled them "Redneck Porn", and I added to them. First one is one of the ones Jeff sent me:

Then another part that came from both Jeff, via Swain Coatings, and a part that came from Rip at Source Automotive:

I have some other porn but they seem to be camera shy, right now. :hehe:

Paul

 

[roachie]

Is that a CR rod?

 

[partsguy662]

I was expecting a picture of sheep..

 

[roachie]

 

[Joesixpack]

MMMMMMMMMM virgin bores......

 

[crewgirl]

MMMMMMMMMM virgin bores......

I'm sending you a cleaning bill for my bedspread cuz I just spit coffee all over it.

 

[SKYNYRD]

hold on fellas be back in a minute or two!!!:what:

 

[SKYNYRD]

oh i'm back!!

 

[cumminspuller]

I'm sending you a cleaning bill for my bedspread cuz I just spit coffee all over it.

LOL

 

[Got Twins???]

Paulb...what it cost you to have the pistons coated? What material did they coat them with?

 

[roachie]

 

[Snedge]

That is one hot momma right there Paul. I didn't touch her, but oh how I wanted to:hehe::hehe::hehe::hehe::hehe::hehe:

 

[getblown5.9]

Then another part that came from both Jeff, via Swain Coatings, and a part that came from Rip at Source Automotive:

What piston is that? would it work well for a p-pumped 24v...seems to have a very wide bowl which would allow for higher timing???

 

[4x4dually]

I was hoping for a picture of sheep..

Fixed it for ya.

 

[Snedge]

Fixed it for ya.

Chit...Scott has pictures of sheep I'm sure.:hehe:

 

[4x4dually]

Who's your daaaaaaaady? :hehe: Probably even a few sheep in nun outfits. LOL

*sounds of barfing*

 

[paulb]

Is that a CR rod?

It's a billet Crower rod for the Cummins. It does use cr rod bearings (different bearing on the top then on the bottom), but I don't think it's limited to just cr's. It's going in my 05.

 

[paulb]

MMMMMMMMMM virgin bores......

I'm not so sure about that... Jeff had undressed it (unwrapped), before I got it.... LOL

 

[paulb]

Paulb...what it cost you to have the pistons coated? What material did they coat them with?

It ran $62.50 per piston. These pistons are coated with their gold coat on top and pc9 on the skirts. The gold coat is a ceramic coating, and the pc9 reduces friction and retains lubrication. The gold coat is about .002 thick, and the pc9 about .0015.

Paul

 

[paulb]

What piston is that? would it work well for a p-pumped 24v...seems to have a very wide bowl which would allow for higher timing???

It's a stock 05 cr piston. I would think there would be a lot better choices for a p-pumped 24v. Kinda outside of my area though.

Paul