ramtough01
New member
- Joined
- Feb 26, 2008
- Messages
- 2,775
Working on my reverser set up and was wondering what everyone has done for the trans brake of the reverser. I have a profab reverser. Also if anyone has pictures what they did
Mine is a lever on the same pivot point as the shifter. Its pretty simple and don't cost much to make it work. I will try to get some pics later this week.
My pics are not the best, but basically I created a lever on the same pivot as the shifter. It attaches to a bent piece of flat stock that pivots on top of the tunnel and goes to another piece of flat stock that goes to the brake on the SCS trans/reverser. You only need about 1/4" of movement for the brake to work with the SCS.
Hope this helps.