Right hand feed and breather issues/questions

Thanks diesel wrencher I'm just limited on space hopefully figure out a breather tank for it this winter.
 
Well boys I finally did a mishimoto catch can. Put it on and the sucker blew the drain tube for the secondary out the block. God damn I'm tired of fighting oil and blow by on this pig
 
Yeah when it's sitting there idiling it will start pushing oil out around the the drain tube. It's a flexible one. The old motor had this same issue I'm wondering if there's a head issue or gasket. The head was done by the same d bag that did yours Colton
 
sounds like some serious blow by, bullet. Try a breather on the oil fill and a couple v covers ? IDK, have you done comp test/ leak down.
 
wildbill144 said:
sounds like some serious blow by, bullet. Try a breather on the oil fill and a couple v covers ? IDK, have you done comp test/ leak down.
Click to expand...

No I haven't. The old motor did the same thing with 142 on the clock. It was a 53 and cracked. Donor block was honed and the bores were within 2 thousands. I used hasting rings. I hope I don't have a weak cylinder. Truck has been towing since day one to break in
 
Updating this thread finally. I capped off my vent from the lift pump plate and used a mr gasket breather for the oil fill and have just the baffled 12v tappet. Completely fixed my oil loss issues.
 
I ended up with a 1" hose on my vc.
 

Attachments

  • 20170924_143811.jpg
    20170924_143811.jpg
    243.6 KB · Views: 0
I haven't read completely through this thread, but a shot vacuum pump can push air into the crankcase.
 
9724VF350 said:
I haven't read completely through this thread, but a shot vacuum pump can push air into the crankcase.
Click to expand...

I've read that but never figured out how to seat one. I guess cap off the vacuum and run see if it shoots oil out still?
 
You must log in or register to reply here.
Back
Top