S400 owners, Measurement needed please

P

popeye55

New member
Joined
Aug 4, 2010
Messages
64
I am trying to get some averages for a project I'm working on. I am looking for anyone with access to a good S400 based Borg charger and a micrometer. With an assembled turbo can you measure the thickness of the compressor nut "not the width" and then a measurement of the amount of shaft/thread protusion. Example my S475 compressor nut was .400 and the shaft end protrusion was .250. If you have a non OEM wheel please let me know as well as that could change the protrusion measurement. Thanks in advance! :nos:
 
It's hard to get square on the end of the nut, but I am getting .415" and .265" shaft protrusion.
 
Anyone else have one setting around? Need about 10 more measurements for a good average.
 
I can get one after the first of the year. Mine is 150 miles away from me.
 
Super helpful..... few more and I will have about 10 different chargers to use for a good average
 
You must log in or register to reply here.
Top