shooting for 900 hp.

Y

yeah___Buddy

New member
Joined
Dec 1, 2009
Messages
35
what do i need? hahahah jk. ok so i have been building my truck for about 2 years now. and i want to change out the internals, pistons rods? (what point do i need them) looking to put triples maybe a 62 with two 64's and a hamilton head. looking for ideas. combintaions. once i get the truck back for the transmission shop im gonna pull the engine and go from there. thanks
 
What injectors? Twins or triples, either should be able to do the job.
 
how many times you want to make 900? big azz injectors and lots of nitrous will get you there easy.. maybe even throw an external gate on there if you want to do it more than once..
 
right now i have 5x18 injectors. i would like triples, what size twins would do it? s362 over a s480? with a egate? i would like to make it on fuel, but if i have to add w/m in fine with that.
 
your prolly going to want another pump then.. i would say a 62 over an 82 with maybe a small ex gate to drive the 82 a bit harder would get you there.. its going to a bit harder than just that. and no you dont need different rods or pistons to do it..
 
**** didnt you know everybody can make 900 hp now a days. look at all the 900 hp trucks with just exhaust and a chip, It must be easy
 
^^ Yeah he's difinitely right. Just add up all the advertised numbers for 1) Intake 2) Exhaust 3)Injectors 4)pump

Intake= probable 30. Exhaust probably another 30, 38 if you go with the 5 inch. If you have a 215 pump= 215 ponies obviously. Then all you need is 525 horses woth of injectors and NOS, thats with the 4 inch. With the 5 inch exhaust you only need 518.
 
JTaylor said:
Well it all starts with a Mare and a Stallion...
Click to expand...

diesel power is light years ahead in time... Just think, It would take two horses (mare and stallion) 825 years at a minimum to produce 900 horses, they would be long gone btw. Where now days with the right money you can have it done in a matter of days and compacted into one little engine bay... MIRACULOUS!
 
Last edited:
cumminstroked said:
diesel power is light years ahead in time... Just think, It would take two horses (mare and stallion) 825 years at a minimum to produce 900 horses, they would be long gone btw. Where now days with the right money you can have it done in a matter of days and compacted into one little engine bay... MIRACULOUS!
Click to expand...

Not when you have 160 to 215 Horses to begin with...
 
I'd get something a little bigger than an S480...injectors should probably be good. If triples, I'd do 62mm turbos. I'm assuming you meant without nitrous by the way, no matter what anyone else says about my sig ;)
 
You must log in or register to reply here.
Back
Top