Valve body ?

[$spendyplayer$]

Will a 47rh valve body work in a 47re Trans ?

 

[ahale2772]

it will fit, but will not "work"

the RH is hydraulically governed by a sinning governor assembly in the tail housing.

now, will a constant pressure full manual RH VB work? that is a questions I'd like to know.

 

[bsmith]

If Its a manual vb

 

[ThatGuy01]

it will fit, but will not "work"

the RH is hydraulically governed by a sinning governor assembly in the tail housing.

now, will a constant pressure full manual RH VB work? that is a questions I'd like to know.

I've always wondered this too, full manual meaning you cannot just slap it in drive and go correct? If so I don't see why not seeing as it doesn't need governed.

 

[joefarmer]

The shifter stem is a different size. So no, it's not a direct fit without boring it or a sleeve.

 

[ahale2772]

^good call, never thought of that

other than that, does an RH full manual VB require a gov signal?

 

[Ghostman]

How do you set max line pressure though without some sort of input, IE: TV cable?

 

[JQmile]

How do you set max line pressure though without some sort of input, IE: TV cable?

Zip tie the lever on the trans that the TV cable would hook to, to "full throttle."

 

[Ghostman]

Zip tie the lever on the trans that the TV cable would hook to, to "full throttle."

But your still getting a govn signal doing that. It's just wide open signal all the time.


Sent from my iPhone using Tapatalk

 

[12vCumminsFTW]

I have a manual RH vb in a RE case, the shifter stem in the same size, but the electrical connector is smaller on the RH. We had to make a sleeve so it would seal.




Sent from phone

 

[joefarmer]

I have a manual RH vb in a RE case, the shifter stem in the same size, but the electrical connector is smaller on the RH. We had to make a sleeve so it would seal.




Sent from phone

Good catch! I was thinking of the wrong hole.

 

[Ghostman]

Good catch! I was thinking of the wrong hole.

:hehe::hehe: