Search results

So I've been running a 4500 in my 91 for several years, it's always frustrated me that it will fill the front of the tcase adapter with oil. Figured this might help someone if they wanted to try the same. I machined the 4wd extension housing to accept the seal in the photo.

Figured I'd share a few photos of today project for my 91. Not as much tech on here as could be sometimes and maybe this will help someone else one day. But built a panhard today, heim on one end and bushing on the the other one LH and one RH for adjusting. Wasn't able to match the full length...

So FDS doesn't do just a max and balance service anymore and I understand why,but who else reputable does? I've got a couple pumps for some project trucks that I'd like to have done. Thanks

I've got two S300s I have acquired from catipillar applications, I'm having trouble finding much info about them. Have called a few BW dealers with little success. Hoping someone on here might could help. First # P/n. 269-2919 S/n. S300ad072 .080 housing I believe Second# P/n 191-8019 S/n...

So I have a real head scratcher right now. Needing some help from those more knowledgeable than myself. I have a 91 1st gen I've been running a 97 215hp engine in for several years. Engine has been getting more and more tired so I tore down a 96 for a rebuild while still driving the 91. New...

I collected this stuff in hopes of doing a swap but it didn't work out, truck I was supposed to buy got away. 95% of everything is there for a swap. So here's what I got. -Dana 60 Front from a dually 3:73 easily swapped to srw and complete -front d/s -rear d/s from a 4d longbed -front...

So little back story about truck. It's an 05 with nv5600. Truck has set of BD r700 compound, T&C pump, Flux 3.5s and a Fass 150. Injectors were sent to F1 when truck had ~134k and now has 140k. I must say that truck never started or sounded so smooth or quiet since I've owned it. Approximately...

I live in central NC and have been looking for a shop at least hone a 12v for me or possibly assemble long block depending on work schedul. Anyone have any suggestions of who might have a torque plate. I don't mind driving a little ways. Thanks

Located in Sanford NC. Travel to Kings Mtn. Nc and back weekly. HT80 88/145 inducer 110/128 exducer .42A/R I believe its new don't look to ever been ran but I would inspect. $450 HT4B 84/140 inducer 88/117 exducer. .35A/R. T-6 Needs rebuild, don't think wheels have made contact...

i'm going to be swapping nozzles on my injectors in the next day or so, i forgot to order a injector holder tool(pc of sheet metal with key hole shape). Would someone be kind enough to measure the two radii and overall distance of key hole shape so i can burn one out and won't have to extend my...

thinking about going ahead a ordering a SB 3250 or 3600 for my 91. im running a nv 4500 in it. what is everyone doing for a better slave/master combo?

Anyone ever changed the front drive shaft to be able to run a bigger u-joint? I had a hard time keeping them together before in lifted my truck and now the little 1310 tries to bind up with very little axle articulation. I was thinking maybe just change the bottom(female slip) portion of the...

where does everyone buy parts to repair their g56? got one with 3rd messed up and gonna rebuild it for my first gen.

been reading good info on here for years and just registered