gatorskinseats5
New member
- Joined
- Apr 14, 2013
- Messages
- 140
destroked 12v/24v to 4r100 adapter plate+transmission bolts-asking 750 shipped
destroked 12v/24v to diesel 4r100 billet flex plate- asking 580 shipped
PA performance 6.0 3 bolt starter for that adapter plate+bolts- asking 100 shipped
destroked 12v/24v to 99-03 7.3 superduty engine mounts with holes drilled for engine in forward position with electric cooling fans, no driveshaft modifications+all bolts, even 4 mount to frame bolts,nuts,washers- asking 300 shipped
PCS tcm-2000 for 4r100 with full wiring harness + *12 VALVE P7100 TPS INCLUDED* + tps plug pigtail with its own long ground wire for accurate readings+serial to usb cable so you can plug it into a laptop that isnt from the 90's---900 shipped.
(you also get the tune i was running which was a TPS only tune. it still needs some messing with, like the 3-4 shift to happen a little later and extra references like rpm and MAP but its the best base tune you could probably start with on your own...the one from pcs is terrible)
the big solenoid control plug on PCS harness for passenger side of transmission had its clip broke off during removal but its not really necessary, the plug will stay in the transmission fine without it. quick splices were used for all splicing, so harness is very in tact.. not sure what spec of brown crud is on the white PCS book in the picture, but its not actually on the book, just some dirty fingerprints
the flex plate has some rust color to it in a few spots, nothing a wirewheel wouldnt take care of if you care
THE ADAPTER PLATE has a ding in it from initial swap stages when it hit the cab seam while moving engine in and out to get engine mounts right but its really of no significance unless youre lookin to hang it on your wall cause it looks cool cause it does
parts have between 10000 -12000 miles on them and have been on a 12 valve, 24 valve, and a 24 valve in a 12 valve block. i put a 7.3 back in my truck and i love it so i dont need this stuff anymore
located in 44260 ohio
asking 2300 shipped for everything. dont b!tch, just message me if youre serious about an offer and you may be pleasantly surprised where it gets you
destroked 12v/24v to diesel 4r100 billet flex plate- asking 580 shipped
PA performance 6.0 3 bolt starter for that adapter plate+bolts- asking 100 shipped
destroked 12v/24v to 99-03 7.3 superduty engine mounts with holes drilled for engine in forward position with electric cooling fans, no driveshaft modifications+all bolts, even 4 mount to frame bolts,nuts,washers- asking 300 shipped
PCS tcm-2000 for 4r100 with full wiring harness + *12 VALVE P7100 TPS INCLUDED* + tps plug pigtail with its own long ground wire for accurate readings+serial to usb cable so you can plug it into a laptop that isnt from the 90's---900 shipped.
(you also get the tune i was running which was a TPS only tune. it still needs some messing with, like the 3-4 shift to happen a little later and extra references like rpm and MAP but its the best base tune you could probably start with on your own...the one from pcs is terrible)
the big solenoid control plug on PCS harness for passenger side of transmission had its clip broke off during removal but its not really necessary, the plug will stay in the transmission fine without it. quick splices were used for all splicing, so harness is very in tact.. not sure what spec of brown crud is on the white PCS book in the picture, but its not actually on the book, just some dirty fingerprints
the flex plate has some rust color to it in a few spots, nothing a wirewheel wouldnt take care of if you care
THE ADAPTER PLATE has a ding in it from initial swap stages when it hit the cab seam while moving engine in and out to get engine mounts right but its really of no significance unless youre lookin to hang it on your wall cause it looks cool cause it does
parts have between 10000 -12000 miles on them and have been on a 12 valve, 24 valve, and a 24 valve in a 12 valve block. i put a 7.3 back in my truck and i love it so i dont need this stuff anymore
located in 44260 ohio
asking 2300 shipped for everything. dont b!tch, just message me if youre serious about an offer and you may be pleasantly surprised where it gets you
Last edited:
