madmikeismad's new build thread/HD Fab Truck

Not a big deal, I already have a doner drain. Just need to swap it.

Sent from my HTC0P3P7 using Tapatalk
 
Last edited:
If you're concerned about intake temps, just shoot straight water. I've seen a lot of used water/meth kits on the interweb for cheap. A little bit of water goes a long way in a race application.
 
Dallas @ HSM said:
If you're concerned about intake temps, just shoot straight water. I've seen a lot of used water/meth kits on the interweb for cheap. A little bit of water goes a long way in a race application.
Click to expand...
I didn't think of that. Never would have thought water injection was that effective. If I do that, I'll need a steel intake flange or 2. Anyone sell cheap ones?

Sent from my HTC0P3P7 using Tapatalk
 
madmikeismad said:
Thank you Will.

Even though I'm trying to sell it, Joe has kinda talked me into trying to have it ready to race this season, possibly in time for D4D. So I'm trying to get it running with the parts I have accumulated. I think the hood stack is all I have left to figure out. And the oil drain. At this point, it looks like it will be going nearly horizontal for a few inches, and that kinda scares me.

Managed to get the turbo mounted up finally.
Click to expand...

How did I miss this? AWESOME!
 
You must log in or register to reply here.
Back
Top