Kill
New member
- Joined
- Jul 24, 2011
- Messages
- 215
3/4" drain seems on the small side when factory dodge is 7/8"?
3/4" should be fine, a lot of guys use -10 AN braided line (5/8") and don't seem to have any problems.
3/4" drain seems on the small side when factory dodge is 7/8"?
3/4" drain seems on the small side when factory dodge is 7/8"?
I didn't think of that. Never would have thought water injection was that effective. If I do that, I'll need a steel intake flange or 2. Anyone sell cheap ones?If you're concerned about intake temps, just shoot straight water. I've seen a lot of used water/meth kits on the interweb for cheap. A little bit of water goes a long way in a race application.
Thank you Will.
Even though I'm trying to sell it, Joe has kinda talked me into trying to have it ready to race this season, possibly in time for D4D. So I'm trying to get it running with the parts I have accumulated. I think the hood stack is all I have left to figure out. And the oil drain. At this point, it looks like it will be going nearly horizontal for a few inches, and that kinda scares me.
Managed to get the turbo mounted up finally.