Recent content by Cummin_un_glued

I have a set of rockwell axles that i would like to sell. The front is a FDS78 which has been narrowed to 70" WMS and the rear is a stock F106. Here is a link to the thread where i narrowed the front. http://www.competitiondiesel.com/forums/showthread.php?t=127095 Both axles have 6.20 gears. I...

3 way dump valve required or not?

24v cummins Whats everyones thoughts on injector protrusion and its effects on timing / tuning.

so I thought that the nut on them was M27x1.50 but the nut dosnt want to screw in the freshly tapped hole and when I measure my tap it is .020" smaller then the threads on the KDEL nut. Checked the pitch it is correct. any help?

Ran fine when pulled $350 shipped

Competition series no belt groove $300 shipped

6.7 pistons drag engine big compounds ppump Filled and bored 5.9 block Stock 6.7 block Go....

Drawing up prints for the machine shop. Any input? Fire Rings Fire Rings Photo by torquedieselllc | Photobucket KDEL injector bore KDEL Photo by torquedieselllc | Photobucket anybody see any flaws?

Nice to see you guys giving the forum users what they want Thanks to Phil or Timbeaux or Billy or who ever added this!

i'm sure this has been discussed but I cant seem to pull up what i'm looking for in search. whats everyones experiences when going from 093 to 120 lines. looking for same setup only change being line size. i'm sure that timing will be retarded some as I had to add 2* when I went from 084 to...

How come there isn't a Sub forum for events under drag racing like there is under sled pulling? While were on the subject could we at least make this thread for this years events? The ones I am interested in are the ones like the bash on the bayou, rudys and those, not just the NHRDA events.

does anyone know yet if there are any plans to pull 2.5 at TS or SDX?

OK so I been out of the pulling scene for a while. Have been working on a drag truck. So I am behind times a bit. Can someone give me some specifics on a 2.5 legal s400 charger? Can pm if you don't want your info out. Sent with a Droid RAZR in one hand and 14,000 volts in the other.

i'm needing a tcase shifter for a second gen that pivots from the floor not from the side of the transmission, i'm putting a G56 in a 12v

got a truck at the shop doing something I havnt seen before. when you start it the thing immediately go's into a lope for about 10 sec then it dies. restarts just fine but again instant lope. no throttle either does the same thing with the tps unplugged. everything checked out on the scanner...