I went to the dealer and ordered new bolts for my fluiddampner only to get them and of cource WRONG size. I don't want to run to the hardware store with only 3 bolts in. So if someone could tell me what size they are, it be appreciated.
I'm looking for a diagram for the 3-4 shift solenoid control on the '05 DODGE RAM, of cource. All I need is the numbers on the plug, 1-6 on the solenoid plug, then on the main elect. plug that's on top of the trans.
Thanks in advance.
on the inlet/outlet of the i.c.?? Someone told me that they did it for their import car and it made a big diff. With the i.c. being chilled, the air that hit the int. was nice and cold.
I'm just checking to see if anyone has tried this and what was the results..
Truck has been running perfect for a few months now.....'cept trip the cel with #1/#2 low voltage heater ( I removed stock fuel filt. and heater grid-made my own block and sealed up the wires). I got a wild hair/idea to pull the fuse and relay for the heater... I started it up and when I got to...
My truck ran fine until I got the idea to pull the heater fuse and relay. Some early mornings when chilly enough, the eng. check lit up and low voltage for 1&2 heater code would be on the smarty. I'd clear up at lunch time, never had any power issues though.
After I pulled the fuse and relay, I...
I've seen somewhere that someone was running slicks/DOT slicks that where 12'' wide. I'm trying to find out what rims and tires they where, the sizes of each. I don't think 15'' rims will clear the rear brake calipers darn it, I wish it would 'cuz of there are plenty of slicks in 15''s and are...
Has anyone installed a floor shifter for their auto trans.?? I don't think there is one out for the 5sp or 6sp. but has anyone modded one to make it work??
Reason I'm asking is 'cuz my cable is kinda sloppy, some play when it's in 'D' position. Does anyone else exp. this?? I haven't priced one...
I tried advanced search and came up with nothin'
What's the most rp I'd want to hit while racing??
Also, in what sequence should a mp-8 and quads rp gauge be plugged in??
Thanks in advance for the replies.......
I've had this for about a yr., bought new and never had any problems. When I recieved the cl tune, I bought a new sdi card for it in case something happened and I had back up, so 2 sdi cards (original from bullydog and cl tune) with it as well as the pillar mounting pod.
I'm running an...