Recent content by nick b

have a 3rd gen killer b 63.5/65/.80 has around 40k miles it is still very tight no play 1000.00 or best offer

if anyone has a front receiver hitch they want to sell pm me

installed a fass on my 99 today. have one small issue just seeing if anyone else has ran across this. the ecm is not sending voltage to the lift pump till after the truck has started wont even turn on if you bump the key. im leaning toward my ecm is half dead or retarded. only solution i have...

hell bent steel 2 inch leveling kit never installed. 50 bucks you pay the shipping

need a 2nd gen intercooler. if you have one pm me

quick question about the helix 2. how much piston protrusion is to much for it and what about valve face depth. i noticed on the Hamilton they list the max specs but i have never seen any on yours. do i not need to worry about it?

set of f1 sportsman springs for 24v bought them used here only had 5k on them i never installed them. 350 obo

z gap rings for std. bore 2nd ring for cummins pistons. they have been sitting on my desk for 6 years i will never use them 100 obo

doe anyone have a #10 or #11 i have been wanting to try one of the two out and see how they run. if anyone shoot me a pm thanks nick

i have a set of gapless rings. thought i would use them but decided against them. its a set of 6 for the 2nd ring only. no top ring or oil ring is included. think they came from haisley. 110+shipping

i was fixing a oil leak today on the timing case. All was going well until i put the balancer on. when i was tightening the bolts looked up the torque spec in the Haynes manual:badidea: i didn't have my fsm out it said 135 ft pounds. seemed a bit high to me but i went ahead an tried to tighten...

looking for a chunk off a bed to patch a stack hole. if anyone has a 2nd gen bed there going to scrap?

i am looking for a clean 12 valve. 3/4 ton 4x4 5 speed. preferably in any state close to oklahoma. i have searched craigslist dry. if anyone does pm me that's the best way to get a hold of me

im a bit lost on piston rings. what is everyone using besides the cummins. any good aftermarket rings or should i stick with cummins rings. also what about z gaps i have a set sitting here but not sure if want to use them. i keep hearing not to use them in a street truck but i cannot find the...

i was looking at the set of rods i have for my motor and the bushing on the rod looks alright. i would like new ones they can be replaced cant they. i glanced at the fsm and it just said replace them.