Recent content by StuckinMud

All I have left from my conversion is the down Pipe. The install is seen in my avatar. Stainless 4". fits 99-07 Ford. @nd gen ISB manifold flipped with s300 series flange. Goes all the down beside the trans. Its also wrapped. 100.00 + shipping I can send a pics.

Brand new QSB 480 5.9 Cummins Pistons .020" oversize, Cummins ring package and new Cummins wrist pins. These pistons have been double heat treated during manufacturing and used in marine or in our case performance applications. They are known to be 30% stronger than the auto version. Purchased...

05 CR CP3 85k works perfect, holds 26k with BMS injectors and smarty. 400.00

Parted out my fummins. Motor mounts. This is the 2 cast brackets on the cummins block, the rubber mounts and the receiving mounts that bolt to the trucks frame. Also includes modified trans mount (not cross member) and rubber trans mount. Everything needed to mount a cummins/ 47re and a 48re...

Motor mounts R,L and modified trans mount for cumins in superduty. Fits 48re in Superduty. 300.00 05 CR/48re 6.0l wire harness This is the 6.0l harness inside the CR harness everything taped up. just need to splice into 6.0l computer to have working guages. It is setup to use the Ford...

05 CR from fummins. All parts have less than 85k on them. Everything was 100% stock until 65k Block (perfect condition incl bores) 400.00 Head - has shelf cut off not machined as I hadnt decided which intake to use yet- otherwise perfect. 400.00 Stock CP# held 25+K solid with BMS/QSB480 100...

They are in great shape w/wristpins std. bore. 80k miles 100.00

Solo..as the title says.. Why are they doing this.. when mine went I had no indicators just all of a sudden on a motor that only had 85k and tuned/driven hard for about 15k. So anyone know what's up and if and what should be addressed while its apart?

I need the clamp that holds the center section to the exhaust turbine housing.. LMK what you have.. Thanks !!!

From a parted motor. 110k miles. Only asking core prices but you could bolt on and go with these. 500.00.

Just looking for an HE341 turbine housing.. LMK what you got ! Thanks

Ok guys.. It seems the rod of choice (other than cu$tom Billet rod$) is to use the 12v/24v brazil rod. However it has also been said to never use a rod with an oiling hole on the small end in a motor spinning above 2500 rpm. These rods have them. So whats the real story here..do I continue...

No cracks great shape, tapped for pyro. 100.00

OK .. First I have smoked the search button.. here and else where. It seems there has not been a definitive consensus on use of the QSB piston in the cummins 5.9. Some builders have said that it ultimately yields less power than the emissions & melt prone later 04.5 up design. Others like the...

Well they say your only as good as your last service. Truck is down and last week I ordered a VB. I had them build it while my core was in route to make the swap happen faster. Well the 4th of July was in the middle of that and in the original discussion they were working the following Thurs and...