Recent content by thojer81

Looking for a cold air intake for a 2010 dodge 6.7L. Sent from my SM-G965U using Tapatalk

Should there be an increase in smoke running 275 injectors over stock ones? I had 150's in that I pulled and put rv 275's in. I do have a 62/65/14 turbo. It gives a slight haze when stepping on it then clears up. Does this sound correct for 275's?

I have the 6 speed in my truck now and have already had to put the updated mainshaft in due to twisting the end off. I don't have a p-pump on the truck yet but it won't be long. Im looking for 600-700 hp when I go ahead with the pump swap. My question is should I stay with the 6 speed or go with...

i'd like to try a set of wheel spacers and see if it helps out at all. where should the wheel spacers go front or rear? i read posts about the spacers being hard on front end parts so i thought maybe in the rear. I plan to run the spacers and my procomp rims which have offset buy im not sure...

i have a 241 DHD front half out of my truck. I got another front half and used my back half to get my truck back together. My problem is in my origainal front half it destroyed the plantary gear set and also the sun gear that is in the aluminum housing in the front. have looked all over and...

I have a 12 cm housing forsale. It came on the turbo I traded from one of my buddies and then I upgraded to the 14 cm housing. It will fit a 62/65 Phat shaft or htt equalvilant. Not sure if it will fit anything else. Housing is wastegated. low miles, asking 200 plus the ride.

I have a htt 62/65/12 turbo. I have been looking everywhere to find a 14 cm housing besides going to htt but have had no luck. Does anyone know where one can be gotten or if a oem turbo has one that will fit my truck that i could get.