Search results

Anyone know where I could get a 65mm turbine wheel for a Borg Warner s362 turbo?

Can you just buy the seals only? s300? s400? Price?

I purchase a Dodge SRT hood from him, a long story short. I did not receive the Hood I asked for my money back with no reply's from him after he said he would return my money.

I have a built 48re trans has all billet shafts, Suncoast converter etc. Valve body set at 200psi at WOT. What would be the reason why I keep loosing 2nd gear? I have adjusted the band twice now and I get 2nd gear back but its on borrow time.

Anyone know what year this head is for, Casting number 3954670?

In need of a good rebuilt or rebuildable CR head perfer Southern California.

Trying to make the NHRDA race in AZ, does anyone have a set of rings for a 5.9 Cummins .020 over? Looking for Gapless or Total seal rings?

How much fuel pressure is in the head on the return side? Idle to WOT at it's max?

When you convert a truck for racing what do you guys do about disabling the airbag system in the truck? Can you just pull the wiring, the module and the airbags drivers and passenger out, is there any tricks I should know about?. How do you go about disable the light on the dash? What about...

How much travel do you need for the driveshaft on the trans yoke going into the transfer case? 1inch 1-1/2 to the dust cover seal? I lowered the back about 7 inches from factory height.

Looking for good price on Isspro gauges. 14032 14633 14233 14166

Are the front and rear ends the same on a 2003 to 2006? looking to do a gear change on one truck and swap complete axles on the other. here what they have now. 2003 has 4.10s 2006 has 3.73s change too. 2003 to 3.73s 2006 to 3.42s Can this be done or do both truck need gears changes to do it...

Looking for an S366 T3 Turbine Housing gated. Borg Warner 66/74/80

Does anyone sell an upgraded shaft for a stock 5.9 CP3? Seals or O-rings?

Anybody have a part number for Darton sleeves? It will be for a 5.9 Cummins and it will be for drag racing.

06 Cummins girdle kit with 12mm mains studs and 6.7 rail pressure sensor?

I know the 6.7 and 5.9 have different part numbers but is there a difference? Can you use a 5.9 water pump in a 6.7 block?

Anyone have one they are not using? Bypass plug for Goerend Shift Enhancer.

I had a shop machine and sleeve a 6.7 Cummins block for me we talked about using Darton sleeves. The shop decided on going with this company Freedom Racing engines in Indiana is were they purchased the sleeves from. The company that made them was Quaker city castings. So my question is what are...

Anyone have a used 6.7 Cummins head gasket they can send me? Need it for mock up. 16211 Howland Lane Huntington Beach CA 92647