Search results

http://www.youtube.com/watch?v=6cLjdr2GSwU&feature=youtube_gdata_player Are you serious? The block flexes that much....

Great seller and EXCELLENT communication! Thanks Brandon, will be intouch soon for other used parts we spoke about!!!!!!

I am going a different route and selling this new turbo! Built by River City Turbo,466/74 1.00ar t-3 non gated! Will sell for 900.00 paid 1500.00 for! Glenn

I am still debating on running 03-04 pistons or running my factory 06' pistons and having swain coat them for $78 each. Some have mentioned marine pistons????

Need this done and who is best

Looking for a set of good exaust valves for 06'

I am building my motor and have some left over parts for sale. All parts have 52k on them and are in great shape per machine shop! Camshaft Rods Pistons Tappets Push tubes Springs mp-8 All for $550.00 shipped!

In process of building motor and I need a little info, I am having rods peened and non-destructive tested (x-ray) can someone tell me the callouts for peening rods plz....

Usually boost goes down do to less resistance through system unless more fuel is added

Well I have to do a complete tear down on motor due to an Amsoil BMK-25! while in there I am using A1-H11 head studs. What other fasteners should I use ie. Main caps and rods....?

I did a search and didn't see anything on this. I know I seen this somewhere just not sure where. Any info on this....

Looking for any shops in Sanford Fla area...

I am wanting to put an end to my dual pump delema once and for all. Should I run dials for a D.D with 150-200 stix and a single s-400 series turbo or stay with a single 60-80% pump

Looking for all 6 in good condition.z

I am going to sell my SSR That Bob still has ready to ship. I am needing extra coin to finish truck and will repurchase when done. 700.00 shipped 2nd day!

Like it says looking to do it right the first time also looking for some 150's tips for early 3rd gen

I am going to remove block to inspect for possible damage from Amsoil Bmk-25 system. What are some relatively good cost/gains mods that machine shop can do to block/ crank. I am also installing 188/200 cam so what about bushings being installed....

What stand do you guys recommend to hold fully dressed 5.9. I plan on installing turbo, head and accessories while on stand to be able to put back into truck as complete as possible

As I mentioned in my last thread I am worried about engine damage due to bmk25. I am about to put truck back together after having head checked and surfaced,188/220 cam,push rods,injectors checked(1 bad) new 150 nozzles,t&c pump nodded (80% or so) s466, threaded casting plugs on head,airdog165...

I need the timing cover, the spacer that goes between valve cover and head and boost tube ( cold side) for banks intercooler