Search results

So the case at hand is not by any means "extreme", but it does have me a bit stumped considering the circumstances. I have been working with a customer that has a rather eclectic build, and while being fairly mild, the standard sizing procedures I use, have resulted in two turbo failures, with...

Does anybody make a cast piston (Ferrous ring land) for the 7.3 that doesn't have a bowl cast into it, so that a builder could do a custom chamber?

Looking for a core P7100 that I can use for dimensioning sake. Doesn't have to be useable, just able to be torn down to the bare housing so I can take measurements. Obviously cheaper the better.

1973 IH 1210. Im looking to drop a more modern 2wd front suspension in, basically replacing the whole front of the frame. The truck will see a decent mount of strip time, so I want it to be stable, and I don't like the Leaf spring solid axle up front. I was thinking about sourcing the front...

Anybody happen to know the part number for Bosch P3000 13mm Plungers and Barrels?

Setup is as Follows: 94 IDIT 7.3 178/190@.050 cam 21.5:1 compression 90cc of fuel to 2800rpm, 75cc@3300. Garden hose nozzles HX35 (8 blade 56/82 cold wheel, 12cm housing with bigger puck and through drilled) Made significantly more power at 17psi than it did at 21psi, and after finding the...

Ive been wavering around in choosing a turbo for my P7100 6.9(7.0) IDI currently under construction. I was looking at similar displacements and what turbo's were working good on those engines and had pretty decided on a 471/475 for this setup, running as a single to help keep the bottom end...

Chump change to most of you, and I cant say too much without getting into trouble, but here is a bit of IDI fab. The setup is made to be a bolt on to any 83-94 IDI with very little modifications, that's why the manifolds aren't a little more optimal. The HX35 is just to start off, its modded on...

Anybody run a dedicated (sealed pump supply) oil supply on a P7100? Are there any drawbacks to not running engine oil besides heat and having to change the oil separately?

I have been beating my head over this one for awhile, and I have been chalking it up to a restriction pre-turbo on my previous setup. Does anybody have any issues with exhaust manifold restriction on an S366 causing a low boost issue? Both banks of my exhaust ran through a 2.100" (~3.5 sq.in)...

I have a brand new 8 cylinder P-pump sans gov (Just the pumping part of the pump) and a 6 cylinder 5.9 P-pump for parts for sale. This was going on a V8 project of mine, but I need the funds to build a new engine for my truck, so the pump is up for sale. Numbers on each pump are in the pics...